Table of Contents
Advertisement
Chapter 3 Loss test (bi-directional IL/ORL + Fault Finder)
Configuring the Loss test
Configuring the Loss test
Once FCOMP/FCOMP-PRO function is selected on both units and Loss/ORL refer-
ences have been correctly performed, the configuration and parameters can be set up.
From the Process page, press Setup key.
Figure 15
Process Page
NOTE
Short cuts (loc.ID, Test cable length): directly adjust the locID from both loca-
tions and test cables length.
Each menu can be setup manually, however pre-defined VIAVI SmartConfigs and previ-
ously saved, user-defined, configurations are also available via the key Load Config.
VIAVI Pre-defined configuration files are:
•
IL ORL
•
IL ORL Unidir OTDR
•
TrueBIDIR
•
IL ORL TrueBIDIR
•
IL ORL Fault Finder
22
click
.
User Manual
700MAN203 Rev. 007
click
Advertisement
Table of Contents
