Installation From Another Server; Installation From A Usb Memory Stick - Viavi SmartOTDR Mainframe User Manual

Chapter 11 Maintenance and Troubleshooting
Maintenance procedure

Installation from another server

Before starting the software upgrade via Ethernet, make sure the IP address of the PC
server.
The update can be performed directly onto the equipment, using an http address.
1 Connect the SmartOTDR to a PC via an Ethernet link or via WIFI.
2 Check on the Ethernet or WIFI setup page that the connection mode is defined to
Automatic (Home > Connectivity > Ethernet / WIFI> Mode: Dynamic).
3 On the Home page, press Connectivity icon
4 Press Upgrade icon
5 In the Upgrade Server box:
– On the line Address Type, select Server Name or IP Address.
– Enter the Server Name (if Server Name has been previously selected) or the
Server Address (if IP Address has been previously selected)
6 Select if the new release for SmartOTDR must be automatically detected
(Enable) or not (Disable). See
page
7 Press
The message Verify IP address of PC server appears.
8 Touch Continue.
The list of the software versions available on the PC is displayed next to the
versions installed on the SmartOTDR (see

Installation from a USB memory stick

You must be equipped with a USB memory stick with a minimum capacity of 128 Mo.
Before installing the upgrade, you must format the USB memory stick (see
the USB memory stick onto the SmartOTDR" on page
1 Once formatted, disconnect the USB memory stick from the SmartOTDR using
the key Eject USB available pressing Settings > Expert Tools > Media Utilities.
As for any media formatting, please note that all data present on the USB
memory stick will be irremediably lost.
116
118.
Software Upgrade > Check available
User Manual
.
"Checking new upgrade on VIAVI Server" on
version.
Figure 77 on page
7SMART102 Rev006
.
115).
127).
"Formatting