Tenda MX15 Pro User Manual page 42

Parameter Description
IPTV VLAN ID
Server Name Displayed after you click Advanced if the connection type is PPPoE.
They specify the PPPoE server name and PPPoE service name of the broadband
service that you purchased.
Service Name If you obtain the service name and server name from your ISP when purchasing the
broadband service, you can change them on this page after completing the internet
settings. Otherwise, keep the default settings.
Displayed after you click Advanced.
It specifies the largest data packet transmitted by a network device. Do not change
the value unless:
MTU
A wrong/improper MTU value may cause internet communication problems. For
example, you may be unable to access certain Websites, frames within Websites,
secure login pages, FTP or POP servers.
The MTU value range is as follows:
Used to clone and change the MAC address of the WAN port of primary node.
If the primary node cannot be connected to the internet after internet settings, the
reason may be that the ISP binds internet access information to a MAC address. At
this point, perform MAC address clone and try to surf the internet.
MAC Address Clone
Custom MAC Required when you select Custom for MAC Address Clone under Advanced. You can
Address enter the customized MAC address here.
−
Your ISP or our technical support suggests you change it when you have
problems connecting to your ISP or other internet services.
−
You use VPN and encounter serious performance problems.
−
You used a program to optimize MTU for performance reasons, and now
you have connectivity or performance problems.
−
When the internet connection type is PPPoE, the default value is 1480. Its
allowed range is 1280 to 1492.
−
When the internet connection type is dynamic IP or static IP, the default
value is 1500. Its allowed range is 1280 to 1500.
−
When the internet connection type is PPTP/L2TP, the default value is 1400.
Its allowed range is 1280 to 1460.
−
Default MAC: Keep the factory setting of MAC address.
−
Clone Local Host MAC: Set the MAC address of the Mesh device to the same
as that of the device which is configuring the Mesh device.
−
Custom: Manually set a MAC address.
32
Document version: V1.0