Buttons And Ports - Tenda MX15 Pro User Manual

1.2.2

Buttons and Ports

MX3&EX3
Jack/Port/Button Description
Mesh button.
MESH
Do not hold down the MESH button for 8 seconds unless necessary.
Reset button.
When the device completes startup, hold down this button using a needle-like item
RST
(such as a pin) for about 8 seconds, and then release it when the LED indicator blinks
red fast. If the LED indicator blinks green slowly, the device is reset successfully.
WAN/LAN multiplexing port, WAN port by default.
WAN/LAN
LAN/IPTV multiplexing port, LAN port by default.
LAN
When the IPTV function is enabled, this port is used as the IPTV port only.
PWR Power jack.
MESH, WAN/LAN, LAN, PWR
RST
−
As a networking button: Press this button on this device for about 1 to 3
seconds. The LED indicator blinks green fast, which indicates the device is
searching for another device to form a network. Within 2 minutes, press the
MESH button of another device for 1 to 3 seconds to negotiate with this
device.
−
As a de-networking button: Press this button for about 8 seconds and release
it when the LED indicator blinks red fast. The node is restored to factory
settings, and also removed from the network and no longer automatically
joins in again.
−
When the device is used as the primary node, this port is used as the WAN
port to connect your optical modem, DSL modem, cable modem or
broadband network port.
−
When the device is used as the secondary node, this port is used as the LAN
port to connect your computer, switch, or gaming console.
5
Document version: V1.0