Tenda MX15 Pro User Manual page 108

Enable the Multicast function.
Step 3
Click Save.
Step 4
---End
After completing the configuration, you can watch multicast videos on your terminal devices.
WAN parameters
When the Ethernet cable is intact and connected to the WAN port properly, but a prompt
indicating that no Ethernet cable is connected to the WAN port is still shown on the Internet
Settings page, you can try to change the Speed to 10 Mbps full duplex or 10 Mbps half duplex to
solve the problem. Otherwise, keep the default settings.
To access the configuration page,
Network Settings > WAN Parameters.
The following table describes the parameters displayed on this page.
Parameter description
Speed
1000 M
Auto-negotiation
log in to the web UI
Application
Indicates that the speed and duplex mode are determined through the negotiation
with the peer port.
of the Mesh device, and choose More >
98
Document version: V1.0