The following table describes the parameters displayed on this page.
Parameter description
Parameter
Description
Auto System
Used to enable or disable the auto system maintenance function.
Maintenance
Reboot at
Specifies the time when the Mesh device reboots automatically every day.
Used to enable or disable the reboot delay function.
Delay Reboot
System log
To access the configuration page,
System Settings > System Log.
This function logs all key events that occur after the Mesh device is started. If you encounter a
network fault, you can turn to system logs for fault rectification.
If necessary, you can also export the system logs to your computer by clicking Export to Local.
−
Ticked: The function is enabled. When the time for rebooting approaches, if
there is any user connected to the Mesh device and the traffic over the Mesh
device's WAN port exceeds 3 KB/s, the Mesh device will delay rebooting.
−
Unticked: The function is disabled. The Mesh device reboots immediately when
the specified time for rebooting approaches.
log in to the web UI
of the Mesh device, and choose More >
129
Document version: V1.0