Complete The Parts Replacement - Lenovo ThinkSystem SD650 V3 User Manual

– <userid>:<password> are the credentials used to access the BMC (Lenovo XClarity Controller
interface) of your server. The default user ID is USERID, and the default password is PASSW0RD
(zero, not an uppercase o)
– <ip_address> is the IP address of the BMC.
For more information about the Lenovo XClarity Essentials OneCLI
http://sysmgt.lenovofiles.com/help/topic/toolsctr_cli_lenovo/onecli_r_set_command.html
Note: If disabling UEFI secure boot is needed, run the following command:
OneCli.exe config set SecureBootConfiguration.SecureBootSetting Disabled --bmc <userid>:<password>@<ip_
address>

Complete the parts replacement

Go through the checklist to complete parts replacement
To complete the parts replacement, do the following:
1. Ensure that all components have been reassembled correctly and that no tools or loose screws are left
inside your solution.
2. Properly route and secure the cables in the solution. Refer to the cable connecting and routing
information for each component.
3. If you have removed the tray cover, reinstall it. See
4. Reconnect external cables and power cords to the solution.
Attention: To avoid component damage, connect the power cords last.
5. Power on the solution and any peripheral devices. See
6. Update the solution configuration.
• Download and install the latest device drivers:
• Update the system firmware. See
• Update the UEFI configuration. See
.
dcg_uefi.html
• Reconfigure the disk arrays if you have installed or removed a hot-swap drive or a RAID adapter. See
https://sysmgt.lenovofiles.com/help/topic/lxpm_frontend/lxpm_product_page.html
documentation compatible with your solution.
"Install the tray cover" on page
"Power on the solution" on page
http://datacentersupport.lenovo.com
"Update the firmware" on page
https://thinksystem.lenovofiles.com/help/topic/dcg_uefi/overview_
command, see:
set
44.
201.
for the LXPM
.
Chapter 5 Hardware replacement procedures
40.
.
193