Table of Contents
Advertisement
A video of this procedure is available at YouTube:
BQs0NXGCm6ZwVtMOSykxd
Procedure
Step 1.
Remove the blank bezel fillers if they are installed.
Figure 115. Blank bezel filler removal
Step 2.
If the interface plate was removed, place the interface plate onto the node; then, secure the
interface plate with two Torx T10 screws.
Figure 116. Interface plate installation
Step 3.
Replace the interface plate putty pad with a new one. Make sure to follow
replacement
guidelines.
ThinkSystem SD650 V3 Neptune DWC Tray User Guide
124
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
.
Gap pad/putty pad
Advertisement
Table of Contents
Troubleshooting
