Lenovo ThinkSystem SD650 V3 User Manual page 192

• Go to
https://datacentersupport.lenovo.com/products/servers/thinksystem/sd650v3/7d7m/downloads/driver-
to see the latest firmware and driver updates for your server.
list/
• Go to "Update the firmware" on page 201
Important: Gap pad/putty pad replacement guidelines
• To identify the gap pad/putty pad location and orientation, see
location" on page 37.
• Before replacing the gap pad/putty pad, gently clean the interface plate or the hardware surface with an
alcohol cleaning pad.
• Hold the gap pad/putty pad carefully to avoid deformation. Make sure no screw hole or opening is
blocked by the gap pad/putty pad material.
• The putty pad is unfit for use if the expiry date on its packaging has passed. Acquire a new putty pad for
proper putty pad replacement procedure.
Watch the procedure
A video of this procedure is available at YouTube:
BQs0NXGCm6ZwVtMOSykxd
Procedure
Note: Depending on the model, your solution might look slightly different from the illustration.
Step 1. Install the system board.
a. Carefully hold the front guide pin and tilt the system board at an angle.
b. Align the connectors with the corresponding holes on the front of the node; then, gently slide
the system board forward.
c. Orient the system board on the two guide pins near the rear of the node to insure proper
alignment; then, carefully insert the system board into the node.
Note: Avoid touching the connectors on the system board. Be careful not to damage any
surrounding components inside the node.
ThinkSystem SD650 V3 Neptune DWC Tray User Guide
184
for more information on firmware updating tools.
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
.
"Gap pad/Putty pad identification and