Lenovo ThinkSystem SD650 V3 User Manual page 97

Figure 71. Blank bezel filler installation
If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
Install a drive cage assembly
Use this information to install a drive cage assembly.
About this task
Attention:
• Read "Installation Guidelines" on page 33
work safely.
• Ensure the drives are installed correctly into the drive cage assembly. See
Note: You may need the Gap Pad Kit to perform this task.
Important: Gap pad/putty pad replacement guidelines
• To identify the gap pad/putty pad location and orientation, see
location" on page 37.
• Before replacing the gap pad/putty pad, gently clean the interface plate or the hardware surface with an
alcohol cleaning pad.
• Hold the gap pad/putty pad carefully to avoid deformation. Make sure no screw hole or opening is
blocked by the gap pad/putty pad material.
• The putty pad is unfit for use if the expiry date on its packaging has passed. Acquire a new putty pad for
proper putty pad replacement procedure.
Watch the procedure
A video of this procedure is available at YouTube:
BQs0NXGCm6ZwVtMOSykxd
Procedure
Step 1. Remove the blank bezel fillers if they are installed.
and "Safety inspection checklist" on page 34
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
.
"Install a drive" on page
"Gap pad/Putty pad identification and
.
Chapter 5 Hardware replacement procedures
to ensure that you
82.
89