Lenovo ThinkSystem SD650 V3 User Manual page 170

Figure 164. Processor locations
Watch the procedure
A video of this procedure is available at YouTube:
BQs0NXGCm6ZwVtMOSykxd
Procedure
Note: Depending on the model, your solution might look slightly different from the illustration.
Step 1. Make preparations for this task.
a. Remove the tray from the enclosure. See
40.
b. Remove the tray cover. See
c. Remove the cross braces. See
d. Remove the DIMM comb. See
e. Remove memory modules. See
f. Remove the M.2 backplane assembly. See
96.
g. Remove the drive cage. See
h. Remove the PCIe riser assembly. Depending on your configuration, see
assembly (ConnectX-6)" on page
200)" on page
Step 2. Remove two Torx T10 screws (per node); then, remove the VR (voltage regulator) clamp plate out of
the node.
ThinkSystem SD650 V3 Neptune DWC Tray User Guide
162
.
"Remove the tray cover" on page
"Remove the cross braces" on page
"Remove a DIMM comb" on page
"Remove a memory module" on page
"Remove a drive cage assembly" on page
119,
128, or "Remove a PCIe riser assembly (ConnectX-7 NDR 400)" on page
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
"Remove a DWC tray from the enclosure" on page
43.
"Remove the M.2 backplane assembly" on page
"PCIe riser assembly replacement (ConnectX-7 NDR
45.
75.
106.
86.
"Remove a PCIe riser
138.