Lenovo ThinkSystem SD650 V3 User Manual page 39

• Connect the solution to the management network
4. Power on the solution.
Power button location and power LED are specified in
diagnostics display" on page
The solution can be turned on (power LED on) in any of the following ways:
• You can press the power button.
• The solution can restart automatically after a power interruption.
• The solution can respond to remote power-on requests sent to the Lenovo XClarity Controller.
Note: You can access the management processor interface to configure the system without powering
on the solution. Whenever the solution is connected to power, the management processor interface is
available. For details about accessing the management solution processor, see "Opening and Using the
XClarity Controller Web Interface" section in the XCC documentation compatible with your solution at
https://sysmgt.lenovofiles.com/help/topic/lxcc_frontend/lxcc_overview.html
5. Validate the solution. Make sure that the power LED, Ethernet connector LED, and network LED are lit
with green light, which means the solution hardware was set up successfully.
See "Troubleshooting by system LEDs and diagnostics display" on page 211
the LED indications.
Configure the system
Complete the following procedures to configure the system. For detailed instructions, refer to
"System configuration" on page
1. Set the network connection for theLenovo XClarity Controller to the management network.
2. Update the firmware for the solution, if necessary.
3. Configure the firmware for the solution.
The following information is available for RAID configuration:
•
https://lenovopress.lenovo.com/lp0578-lenovo-raid-introduction
•
https://lenovopress.lenovo.com/lp0579-lenovo-raid-management-tools-and-resources
4. Install the operating system.
5. Back up the solution configuration.
6. Install the applications and programs for which the solution is intended to be used.
211.
199.
"Troubleshooting by system LEDs and
.
for more information on
Chapter 4
Chapter 7
.
Unboxing and setup
31