Replace Components In The Compute Node - Lenovo ThinkSystem SD650 V3 User Manual

Figure 48. VR clamp plate installation
After you finish
1. Install the PCIe riser assembly. See
riser assembly replacement (ConnectX-7 NDR 200)" on page
(ConnectX-7 NDR 400)" on page
2. Install the drive cage. See
3. Install the M.2 backplane assembly. See
4. Install the memory modules. See
5. Install the DIMM comb. See
6. Install the cross braces. See
7. Install the tray cover. See
8. Install the tray into the enclosure. See
9. Connect all required external cables to the solution.
Note: Use extra force to connect QSFP cables to the solution.
10. Check the power LED on each node to make sure it changes from fast blink to slow blink to indicate all
nodes are ready to be powered on.

Replace components in the compute node

Use the following information to remove and install compute node components.
Notes:
• The illustrations in this document are for reference only and might differ slightly from your hardware.
ThinkSystem SD650 V3 Neptune DWC Tray User Guide
70
"Install a PCIe riser assembly (ConnectX-6)" on page 123
144.
"Install a drive cage assembly" on page
"Install the M.2 backplane assembly" on page
"Install a memory module" on page
"Install a DIMM comb" on page
"Install the cross braces" on page
"Install the tray cover" on page
"Install a DWC tray in the enclosure" on page
128, or "Install a PCIe riser assembly
89.
111.
77.
47.
44.
, "PCIe
100.
42.