Table of Contents
Advertisement
Figure 137. Interface plate removal
b.
Release the interface plate with a flat head screwdriver. (If a flat head screwdriver is not
available, the DIMM tool can also be used.)
1. There are two openings (marked with black triangle in the illustration below) on the bottom
side of the interface plate for inserting a flat head screwdriver—select the one that is
accessible for the flat head screwdriver.
2. Insert a flat head screwdriver into the opening; then, slightly rotate the screwdriver to
release the interface plate from the water loop cold plate.
.
Chapter 5
Hardware replacement procedures
141
Advertisement
Table of Contents
Troubleshooting
