Table of Contents
Advertisement
Figure 140. Removing the interface plate
Step 4.
If necessary, install the blank bezel fillers.
Figure 141. Blank bezel filler installation
After you finish
If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
If you need to disassemble the PCIe riser assembly, follow the instructions below:
Attention: You can only disassemble a PCIe riser assembly for recycle. Do not disassemble it for any other
purposes.
1. Remove the two screws, then, separate the expansion board from the cage.
.
Chapter 5
Hardware replacement procedures
143
Advertisement
Table of Contents
Troubleshooting
