Lenovo ThinkSystem SD650 V3 User Manual page 52

• Use extra force to disconnect QSFP cables if they are connected to the solution.
Watch the procedure
A video of this procedure is available at YouTube:
BQs0NXGCm6ZwVtMOSykxd
Procedure
Step 1. Remove the tray from the enclosure. See
Step 2. Press on the release latch and the push point at the same time and slide the cover toward the rear
of the DWC tray.
Figure 17. Tray cover removal
Step 3. Lift the cover off the DWC tray and set it aside.
Note: Service label instructions are located on the underside of each tray cover.
After you finish
If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
Install the tray cover
Use this information to install the tray cover.
About this task
Attention:
• Read "Installation Guidelines" on page 33
work safely.
Note: The following illustration might differ slightly from your hardware, but the installation method is the
same.
ThinkSystem SD650 V3 Neptune DWC Tray User Guide
44
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
.
"Remove a DWC tray from the enclosure" on page
and "Safety inspection checklist" on page 34
40.
to ensure that you