Pcie Riser Assembly Replacement (Connectx-6) - Lenovo ThinkSystem SD650 V3 User Manual

Step 3. Align the adapter with the PCIe slot on the riser-cage; then, carefully press the adapter straight into
the slot until it is securely seated. Fasten the screw to secure the adapter.
Figure 108. PCIe adapter installation
After you finish
1. Install the PCIe riser assembly. See
riser assembly replacement (ConnectX-7 NDR 200)" on page
(ConnectX-7 NDR 400)" on page
2. Install the tray cover. See
3. Install the tray into the enclosure. See
4. Connect all required external cables to the solution.
Note: Use extra force to connect QSFP cables to the solution.
5. Check the power LED on each node to make sure it changes from fast blink to slow blink to indicate all
nodes are ready to be powered on.

PCIe riser assembly replacement (ConnectX-6)

Use the following procedures to remove and install a PCIe riser assembly with ConnectX-6 adapter.
• For PCIe riser with ConnectX-7 NDR 200 adapter, see
NDR 200)" on page 128.
• For PCIe riser with ConnectX-7 NDR 400 adapter, see
NDR 400)" on page 138.
Remove a PCIe riser assembly (ConnectX-6)
Use this information to remove a PCIe riser assembly with ConnectX-6 adapter.
About this task
Attention:
• Read "Installation Guidelines" on page 33
work safely.
"Install a PCIe riser assembly (ConnectX-6)" on page 123
144.
"Install the tray cover" on page
"Install a DWC tray in the enclosure" on page
and "Safety inspection checklist" on page 34
128, or "Install a PCIe riser assembly
44.
"PCIe riser assembly replacement (ConnectX-7
"PCIe riser assembly replacement (ConnectX-7
.
Chapter 5 Hardware replacement procedures
, "PCIe
42.
to ensure that you
119