Lenovo ThinkSystem SD650 V3 User Manual page 130

Step 5. If necessary, remove the hex standoff screw and the two Torx T10 screws that secure the interface
plate; then, remove the interface plate.
Figure 112. Interface plate removal
Step 6. If necessary, install the blank bezel fillers.
Figure 113. Blank bezel filler installation
After you finish
If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
If you need to disassemble the PCIe riser assembly, follow the instructions below:
ThinkSystem SD650 V3 Neptune DWC Tray User Guide
122