Table of Contents
Advertisement
Installation
3.7.4 Drain connection
3.7.5 Detergent and drying agent
3.7.6 Ventilation
The drain is connected using a 50mm metal tube which tolerates mechanical im-
pacts. The drain must run to a floor drain, where its opening must be above the
water level.
The machine comes ready for the connection of a detergent and drying agent sys-
tem. The water outlet for the detergent is located on the incoming hot water pipe.
The drying agent connection is on the pipe leading to the booster heater for the
final rinse water (see the flow diagram). This flow diagram is shown on the inside
of the electrical cabinet.
Contact a suitable supplier to arrange for the equipment to be installed.
Avoid making unnecessary holes in the machine. If possible the equipment
should be placed on a wall next to the machine.
Electrical connections: See the wiring diagram. This wiring diagram is shown on
the inside of the electrical cabinet.
Next to the machine's condensing battery is a connection for ventilation. If a
sound trap is supplied, it is fitted directly to this connection. The connection to the
ventilation system is made using an air gap.
The location and size of the connection are shown on the installation diagram.
A
B
Connection with air gap
A=Ventilation duct 400x105 mm
B=Machine's ventilation connection 400x100 mm
WD-B 500 - WD-B 900
WDB-14
17
Rev. 4.0 (201208)
Advertisement
Table of Contents
