Table of Contents
Advertisement
Installation
3.6.2 Assembly of sections
•
Remove any transport supports.
•
Place section 2 in the appropriate place at the right height. Check that the
section is horizontal using a spirit level (on the tank body). Adjust the ma-
chine using the legs.
•
Fit the joining tube to the stand on section 2.
D
C
B
Assembling the joining tube
A=Leg
B=Stand
C=Joining tube
D=M6x10 Bolts
•
Place section 1 next to section 2 so that the rectangular metal pieces on
the stands of both sections are in line with each other. Check that section
1 is horizontal using a spirit level (on the tank body). Adjust using the legs.
•
Push section 1 against section 2 until the rectangular metal pieces on the
stand are pushed close to each other, but do not push the sections com-
pletely together. There should still be a distance between them in order to
apply the silicon around the openings.
•
Apply plenty of silicon around the openings of both sections and around all
bolt holes. Place two strands of silicon along the lower edge.
•
Push the sections together. Hold them together with a screw clamp and fit
the bolts that hold the hoods together. Lock the stand on the front and back
of the machine using two M6x10 bolts. Check that the machine is horizontal
using a spirit level (on the tank body).
B
B
Application of silicon
A=Bolt hole
B=Silicon
WD-B 500 - WD-B 900
A
Skarvr ör
A
Silikon
11
Rev. 4.0 (201208)
Advertisement
Table of Contents
