Table of Contents
Advertisement
Installation
3.6 Installation
3.6.1 General information
Parts which must be assembled are prepacked inside each machine section to-
gether with the necessary bolts, nuts, etc.
Remove all lower cover plates (5).
The final position of the machine is either free-standing in the room or placed with
the back against a wall. If the machine is to be placed against a wall, the assembly
should be carried out with sufficient space behind the machine for access during
the fitting of components on the back of the machine. The fully assembled ma-
chine is then pushed into position.
The picture below shows a machine with the feed direction from left to right. The
picture shows parts which must be assembled during the installation and the ad-
justing device for tensioning the conveyor belt. The length of the infeed and out-
feed section and the number of zones vary depending on the specific machine.
For this reason, the illustration below shows the approximate position of the com-
ponents in the machine.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
1
2
8
7
Adjusting screws for the conveyor belt
Tension wheel
Upper track
Chain
Coverplate
Drainage plate
Lower track
Belt tensioner
Coverplate
Overflow pipe
WD-B 500 - WD-B 900
9
6
10
10
Rev. 4.0 (201208)
3
5
4
WDB-07
Advertisement
Table of Contents
