Table of Contents
Advertisement
Installation
3. Installation
3.1 General information
The machine must be installed by authorised personnel only.
Read these instructions carefully, as they contain important information regarding
the correct installation method.
The instructions should be used together with the machine drawing, wiring dia-
gram and flow diagram.
he machine is CE marked. The CE mark is only valid for machines that have not
been modified. If the machine is damaged as a result of the instructions not being
followed, this invalidates the supplier's guarantee and the product liability.
3.2 Requirements for the installation site
3.2.1 Lighting
In order to ensure the best possible working conditions during installation, opera-
tion, servicing and maintenance, make sure that the machine is installed in a well-
lit room.
3.2.2 Ventilation
The machine produces heat and steam when in operation. In order to ensure the
best possible working conditions, a certain air change rate is required in the dish-
washing room. The ventilation requirements for the room should be calculated on
the basis of current standards.
3.2.3 Drains
There must be a floor drain with an effective trap for the machine's waste water
and for water used for cleaning. The drain should be located under the machine's
loading bench. The floor drain capacity can be found in the TECHNICAL SPECI-
FICATIONS.
WD-B 500 - WD-B 900
6
Rev. 4.0 (201208)
Advertisement
Table of Contents
