Technical Specifications - Huawei NetCol8000-A013 User Manual

NetCol8000-A013 In-room Air Cooled Smart Cooling
Product
User Manual (800 mm Width)
Item
Water
supply
Power
require
ments
Note: If the requirements are not met, contact Huawei technical support for an
optimized solution.

2.2.5 Technical Specifications

All models (indoor and outdoor units) of this product meet the environmental
protection requirements. The following figure shows the environmental protection
mark.
Figure 2-10 Environmental protection mark
Table 2-5 General specifications for the normal-temperature indoor unit
Item
Cooling
mode
Refrigera
nt
Cooling
capacity
Issue 06 (2022-11-25)
Specifications
The inlet water pressure of the humidifier should be 0.1–0.7 MPa,
and the temperature should range from 1°C to 40°C.
The wet film humidifier uses tap water and does not require an
additional water treatment device at the water inlet. The water
requirements are as follows:
● Non-freezing and nephelometric turbidity units (NTU) < 3
● No visible substances
● 6.5 ≤ pH value ≤ 8.5
● Total hardness (in CaCO
Standards for Drinking Water Quality (GB 5749-2006).
Note: Refer to
Leakage circuit breakers are not recommended for the main power
route. If a leakage circuit breaker is required by the customer or local
regulations, select the residual current circuit breaker (RCCB) that is
insensitive to single-phase DC pulsation and transient impulse
current.
Specifications
Air cooled
R410A
13 kW
a
Copyright © Huawei Technologies Co., Ltd.
) ≤ 450 mg/L
3
2 Overview
23