MacDon R85 Operator's Manual page 155

3. Open driveshield. See Section
28.
4. Place a suitable container under drain plug (A).
5. Remove plugs (A) and (B).
6. Allow sufficient time for lubricant to drain.
7. Replace plug (A) and tighten.
8. Remove breather and bushing (A) at filler pipe (B).
9. Add 11.8 oz. (350 ml) of Traxon E Synthetic 80W90
gear lubricant to gearbox through filler pipe (B).
NOTE: Lubricant should run out of port (C)
slightly when at the proper level.
10. Reinstall plug (C) and tighten.
11. Reinstall bushing and breather (A) in filler pipe (B)
and tighten.
12. Properly dispose of used lubricant and clean up any
spilled lubricant.
13. Close driveshield.
169457
MAINTENANCE AND SERVICING
5.4 Driveshields, page
147
Figure 7.55
Figure 7.56
Figure 7.57
Rev. F