Maintenance Schedule/Record - MacDon R85 Operator's Manual

7.5.1 Maintenance Schedule/Record

Action:
Hour meter reading



First use
100 hours or annually
Conditioner drive belt
 See section
Conditioner Drive Belt, page
Auger drive belts
 See section Inspecting the Auger
Drive Belts, page 150.
Conditioner gearbox lube level
 See Section 7.7.3
Gearbox, page 146.
Bevel gearbox lube level
See Section 7.7.1 Bevel Gearbox,

page 141.
End of season
10 hours or daily
Hydraulic hoses and lines
 See Section 7.8.2 Hydraulic Hoses
and Lines, page 156.
Cutter blades, deflectors, and discs
 See Section 7.6.1 Inspecting the
Cutterbar Discs, page
25 hours
Roll universal shafts
 See Section 7.5.5 Lubrication and
Servicing, page 115.
Cutterbar driveline bearings
 See Section 7.5.5 Lubrication and
Servicing, page 115.
50 HOURS
Cutterbar lube first 50 and 150 hours
▲ See Section 7.5.8 Lubricating the
Cutterbar, page 121.
Bevel gearbox lube level first 50 and
150 hours
▲
See Section 7.7.1 Bevel Gearbox,
page 141.
169457
MAINTENANCE AND SERVICING
 - Check
Service date
Serviced by
Refer to Section
Refer to Section
Inspecting the
142.
Conditioner
Refer to Section
NOTE: A record of daily maintenance is not normally
126.
 - Lubricate
7.5.2 Break-In Inspections, page
7.5.3 Preseason/Annual Service, page
7.5.4 End-of-Season Service, page
required, but is at the Owner/Operator's
discretion.
112
▲ - Change
114.
114.
115.
Rev. F