Lights - MacDon R85 Operator's Manual

5.12 Lights

The transport lights, which are mounted on both ends of the header, are activated by switches in the M Series
windrower cab. See your self-propelled windrower operator's manual on when to use them. The reflectors can be
reversed, depending on the direction of travel. The amber deflector must face the direction of travel.
DANGER
Stop engine and remove key from ignition before
leaving operator's seat for any reason. A child or
even a pet could engage an idling machine.
Change amber reflector (A) orientation as follows:
NOTE: Arrow indicates direction of travel (B).
1. Disconnect wiring harness (C) at light.
2. Remove four bolts (D) and remove light assembly (E).
NOTE: Only two bolts shown in illustration.
3. Repeat for opposite light assembly.
4. Swap locations of light assemblies (E).
5. Reinstall light assemblies (E) so that amber reflector
faces in opposite direction from original installation.
6. Reinstall bolts (D) and connect light to wiring
harness (C).
169457
OPERATION
Figure 5.65: Factory Installation
Figure 5.66: Alternate Installation
63
Rev. F