MacDon R85 Operator's Manual page 148

3. Insert driveline (B) into deflector (C) and install onto
shaft. Ensure that driveline (B) grease zerks will be
accessible through large opening in deflector.
4. Align mounting holes in deflector (C), spindle, and
driveline (B) and reinstall four bolts (A). Tighten bolts.
5. Adjust the upper driveline shield to achieve consistent
gap around deflector shield (C).
6. Tighten bolts (A) on shield plates (B).
7. Remove block of wood (if used).
8. Manually rotate discs to check for interference of
adjacent parts.
9. Close cutterbar doors.
Doors, page 31.
WARNING
Ensure cutterbar is completely clear of foreign
objects. These objects can be ejected with
considerable force
started and may result in serious injury or
machine damage.
169457
MAINTENANCE AND SERVICING
See Section 5.5 Cutterbar
when the machine
Figure 7.43
is
Figure 7.44
140
Rev. F