Installing The Driveline Deflector - MacDon R85 Operator's Manual

4. Locate the deflector (C) with the driveline in the center
of it.
5. Remove the four bolts (A) that secure the driveline (B)
and disc to the spindle.
6. Rotate the deflector (C) as required so that large
opening in deflector faces you.
7. Remove the driveline (B) through the larger opening in
the deflector.
8. Loosen the four bolts (A) in the two plates (B) that hold
the upper driveline shield (C) in place.
9. Move the plates (B) so that shield (C) can be lowered
into deflector (D).
10. Remove the deflector (D).
Installing the Driveline Deflector
Follow these steps to replace the driveline deflector:
1. Locate deflector (D) and upper driveline shield
onto spindle.
2. Raise upper driveline shield (C) into position and slide
plates (B) into slots in shield. Do not tighten bolts.
169457
MAINTENANCE AND SERVICING
139
Figure 7.40
Figure 7.41
Figure 7.42
Rev. F