MacDon R85 Operator's Manual page 151

2. Open the driveshield. See Section
page 28.
3. Inspect the condition of belt (A). Replace if damaged
or showing signs of cracking or separation.
4. Check that adjuster nuts (B) is tight.
5. Check that end of slots (C) are aligned with plate (D).
6. If necessary, adjust tension as follows:
a. Loosen jam nut (E).
b. Turn adjuster nut (B) until end of slots (C) are
aligned with plate (D).
c. Tighten jam nut (E).
7. Close driveshield.
169457
MAINTENANCE AND SERVICING
5.4 Driveshields,
143
Figure 7.48
Figure 7.49
Rev. F