Attaching The Header (M205 Windrowers) - MacDon R85 Operator's Manual

6. Set the forming shield side deflectors to the desired
width by repositioning adjuster bars (A). Use the same
hole location on both sides.
7. Adjust rear fluffer deflector (C) to middle position.
Loosen handles (B) if required.
8. Attach the R85 header to the windrower.
to the MacDon self-propelled windrower operator's
manual, and then return to this manual to complete
the attachment.
9. Connect the hydraulics and electrical harness. See
the following pages for instruction, specific to your
windrower model.

5.7.2 Attaching the Header (M205 Windrowers)

DANGER
Stop engine and remove key from ignition before
leaving operator's seat for any reason. A child or
even a pet could engage an idling machine.
To attach the header to an M205 windrower, follow
these steps.
169457
OPERATION
Figure 5.26
Refer
42
Rev. F