Epson AcuLaser CX17 Series User Manual page 258

Ans Select
Purpose:
To select the default fax receiving mode.
Values:
TEL Mode
FAX Mode*
TEL/FAX Mode
Ans/FAX Mode
DRPD Mode
Auto Answer Fax
Purpose:
To set the interval at which the printer goes into the fax receive mode after receiving an incoming call.
The interval can be specified within the range of 0 to 255 seconds. The default is 0 second.
Auto Ans. TEL/FAX
Purpose:
To set the interval at which the printer goes into the fax receive mode after the external telephone
receives an incoming call. The interval can be specified within the range of 0 to 255 seconds. The
default is six seconds.
Automatic fax reception is turned off. You can receive a fax by picking up the
handset of the external telephone, pressing the remote receive code, and then
pressing (Start) button.
Automatically receives faxes.
When the printer receives an incoming fax, the external telephone rings for the
time specified in Auto Ans. TEL/FAX, and then the printer automatically
receives a fax. If an incoming call is not a fax, the printer beeps from the internal
speaker indicating that the call is a telephone call.
The printer can share a telephone line with an answering machine. In this
mode, the printer will monitor the fax signal and pick up the line if there are fax
tones. If the phone communication is using serial transmission in your country
(such as Germany, Sweden, Denmark, Austria, Belgium, Italy, France and
Switzerland), this mode is not supported.
Before using the Distinctive Ring Pattern Detection (DRPD) option, a distinctive
ring service must be installed on your telephone line by the telephone
company. After the telephone company has provided a separate number for
faxing with a distinctive ring pattern, configure the fax setup to monitor for that
specific ring pattern.
Using the Operator Panel Menus and Keypad
Epson AcuLaser CX17 Series User's Guide
258