Epson AcuLaser CX17 Series User Manual page 245

Option
Ans Select TEL Mode
FAX Mode *
TEL/FAX Mode
Ans/FAX Mode
DRPD Mode
Auto Answer Fax
Auto Ans. TEL/FAX
Auto Ans. Ans/FAX
Line Monitor
Ring Tone Volume
Line Type
Dialing Type
Interval Timer
Number of Redial
Redial Delay
Description
Automatic fax reception is turned off. You can receive a fax by picking up the
handset of the external telephone, pressing the remote receive code, and
then pressing the (Start) button.
Automatically receives faxes.
When the printer receives an incoming fax, the external telephone rings for
the time specified in Auto Ans. TEL/FAX, and then the printer automatically
receives a fax. If an incoming call is not a fax, the printer beeps from the
internal speaker indicating that the call is a telephone call.
The printer can share a telephone line with an answering machine. In this
mode, the printer will monitor the fax signal and pick up the line if there are
fax tones. If the phone communication is using serial transmission in your
region, this mode is not supported.
Before using the Distinctive Ring Pattern Detection (DRPD) option, a
distinctive ring service must be installed on your telephone line by the
telephone company. After the telephone company has provided a separate
number for faxing with a distinctive ring pattern, configure the fax setup to
monitor for that specific ring pattern.
Sets the interval at which the printer goes into the fax receive mode after
receiving an incoming call.
Sets the interval at which the printer goes into the fax receive mode after the
external telephone receives an incoming call.
Sets the interval at which the printer goes into the fax receive mode after the
external answering machine receives an incoming call.
Sets the volume of the line monitor, which audibly monitors a transmission
through the internal speaker until a connection is made.
Sets the volume of the ring tone, which indicates that an incoming call is a
telephone call through the internal speaker when Ans Select is set to TEL/
FAX Mode.
Sets the line type.
Sets the dialing type.
Note:
This menu is not displayed when Region is set to South Africa.
Specifies the interval between transmission attempts.
Specifies the number of redial attempts to make when the destination fax
number is busy. If you enter 0, the printer will not redial.
Specifies the interval between redial attempts.
Faxing (Epson AcuLaser CX17NF/CX17WF Only)
Epson AcuLaser CX17 Series User's Guide
245