Epson AcuLaser CX17 Series User Manual page 107

10. Print a System Settings page from the operator panel.
See "Printing a System Settings Page" on page 149.
11. Confirm that "Link Quality" is shown as "Good", "Acceptable" or "Low" on the report.
Note:
When "Link Quality" is "No Reception", check if the wireless settings are correctly configured.
WPS-PIN
Note:
❏ WPS-PIN is a method to authenticate and register devices required for wireless configuration, by
entering PIN code to a printer and computer. This setting, performed through access point, is
available only when the access points of your wireless router supports WPS.
❏ Before WPS-PIN starts, you will need to enter your PIN code at the web page of the wireless access
point. See the access point manual for the details.
1. On the operator panel, press the System button.
2. Select Admin Menu, and then press the
3. Select Network, and then press the
4. Select Wireless Setup, and then press the
5. Select WPS, and then press the
6. Select PIN Code, and then press the
7. Take a note of PIN code displayed on the operator panel.
8. Select Start Configuration, and then press the
9. If SSID selection screen appears, select the SSID, and then press the
10. Enter the PIN code of the printer at the web page of the wireless access point.
11. Wait a few minutes until the printer restarts to establish the wireless network.
12. Print a System Settings page from the operator panel.
button.
button.
button.
button.
button.
button.
Printer Connection and Software Installation
Epson AcuLaser CX17 Series
button.
User's Guide
107