Epson AcuLaser CX17 Series User Manual page 105

When you select WEP(64Bit) or WEP(128Bit) for an encryption type at step 8, select a transmit
key after entering the WEP key.
10. Wait a few minutes until the printer restarts to establish the wireless network.
11. Print a System Settings page from the operator panel.
See "Printing a System Settings Page" on page 149.
12. Confirm that "Link Quality" is shown as "Good", "Acceptable" or "Low" on the report.
Note:
When "Link Quality" is "No Reception", check if the wireless settings are correctly configured.
Using Ad Hoc Connection
To configure the wireless settings for an ad-hoc connection where the wireless devices communicate
directly with each other without an access point:
1. On the operator panel, press the System button.
2. Select Admin Menu, and then press the
3. Select Network, and then press the
4. Select Wireless Setup, and then press the
5. Select Manual Setup, and then press the
6. Enter the SSID, and then press the
Use the numeric keypad to enter the desired value, and press the
7. Select Ad-hoc, and then press the
8. Select an encryption type, and then press the
Important:
Be sure to use one of the supported encryption methods to protect your network traffic.
9. Enter the WEP key, and then press the
Use the numeric keypad to enter the desired value, and press the
Epson AcuLaser CX17 Series
button.
button.
button.
button.
button.
button.
button.
button.
Printer Connection and Software Installation
User's Guide
or button to move a cursor.
or button to move a cursor.
105