Command Quick Reference - HP E1419A User Manual

Command
ABORt
ALGorithm
[:EXPLicit]
:ARRay <alg_name>,<array_name>,<block_data>
:ARRay? <alg_name>,<array_name>
:DEFine <alg_name>[,<swap_size>],<program_data>
:SCALar <alg_name>,<var_name>,<value>
:SCALar? <alg_name>,<var_name>
:SCAN
:RATio <alg_name>,<ratio>
:RATio? <alg_name>
:SIZe? <alg_name>
:STATe <alg_name>,ON | OFF
:STATe? <alg_name>
:TIME? <alg_name> | MAIN
:FUNCtion
:DEFine <function_name>,<range>,<offset>,<func_data>
:OUTPut
:DELay <delay> | AUTO
:DELay?
:UPDate
[:IMMediate]
:CHANnel (@<channel>
:WINDow <num_updates>
:WINDow?
ARM
[:IMMediate]
:SOURce BUS | EXT | HOLD | IMM | SCP | TTLTrg<n>
:SOURce?
CALibration
:CONFigure
:RESistance
:VOLTage <range>, ZERO | FSCale
:SETup
:SETup?
:STORe ADC | TARE
326 HP E1419 Command Reference
The following tables summarize SCPI and IEEE-488.2 Common (*) commands for
the HP E1419A Multifunction3OXV.
SCPI Command Quick Reference

Command Quick Reference

Description
Stops scanning immediately and sets trigger system to idle state (scan
lists are unaffected)
Subsystem to define, configure, and enable loop control algorithms
Defines contents of array <array_name> in algorithm <alg_name> or if
<alg_name> is "GLOBALS", defines values global to all algorithms.
Returns block data from <array_name> in algorithm <alg_name> or if
<alg_name> is "GLOBALS", returns values from a global array.
Defines algorithms or global variables. <program_data> is 'C' source of
algorithm or global declaration.
Defines value of variable <var_name> in algorithm <alg_name> or if
<alg_name> is "GLOBALS", defines a value global to all algorithms.
Returns value from <var_name> in algorithm <alg_name> or if
<alg_name> is "GLOBALS", returns a value from global variable.
Sets scan triggers per execution of <alg_name> (send also ALG:UPD)
Returns scan triggers per execution of <alg_name>
Returns size in words of named algorithm
Enables/disables named algorithm after ALG:UPDATE sent
Returns state of named algorithm
Returns worst case alg execution time. Use "MAIN" for overall time.
Defines a custom conversion function
Sets the delay from scan trigger to start of outputs
Returns the delay from scan trigger to start of outputs
Requests immediate update of algorithm code, variable, or array
Sets dig channel to synch algorithm updates
Sets a window for num_updates to occur. *RST default is 20
Returns setting for allowable number variable and algorithm updates.
Arm if ARM:SOUR is BUS or HOLD (software ARM)
Specify the source of Trigger Timer ARM
Return current ARM source
Prepare to measure on-board references with an external multimeter
Configure to measure reference resistor
Configure to measure reference voltage range at zero or full scale
Performs Channel Calibration procedure
Returns state of CAL:SETup operation (returns error codes or 0 for OK)
Store cal constants to Flash RAM for either A/D calibration or those
generated by the CAL:TARE command
Chapter 6