Memory:vme:state - HP E1419A User Manual

MEMory
Usage

MEMory:VME:STATe?

Comments
Usage
248 HP E1419 Command Reference
•
When the VME memory card is enabled, the INIT command does not terminate
until data acquisition stops or VME memory is full.
•
Related Commands: Memory subsystem, and FETCH?
•
*RST Condition: MEM:VME:STAT OFF
MEMORY:VME:STATE ON
MEM:VME:STAT 0
MEMory:VME:STATe? returned value of 0 indicates that VME reading storage is
disabled. Returned value of 1 indicates VME memory is enabled.
•
This command is only available in systems using an HP E1405B or HP E1406A
command module.
•
Returned Value: Numeric 1 or 0. C-SCPI type uint16.
•
Related Commands: MEMory subsystem, and FETCH?
MEM:VME:STAT?
enable VME card as reading storage
Disable VME card as reading storage
Returns 1 for enabled, 0 for disabled
Chapter 6