Scpi Command Quick Reference - HP E2261A User Manual

Command Subsystem
DIAGnostic:LINE <interrupt_line>
:LINE?
:SERial[1|2|3|4]
:CLEARbuffer TX | RX | TXRX
:RECeive
ÄVAilable?
:CHANnel ENABle | DISAble
:CHANnel?
:STATus?
:TRANsmit
:BUFFerstatus?
:CHANnel ENABle | DISAble
CHANnel?
SENSe:SERial[1|2|3|4][:TEXT?] [ n ]
:DATA? [ n ]
SOURce:SERial[1|2|3|4][:TEXT] <"text string">
:DATA <data>
STATus:OPERation:CONDition?
:ENABle <mask>
:ENABle?
[:EVENt]?
:PRESet
:QUEStionable:CONDition?
:ENABle <mask>
:ENABle?
[:EVENt]?
SYSTem commands are provided on next page.
52 SCPI Command Reference

SCPI Command Quick Reference

Description
Sets interrupt level between 0 and 7.
Returns interrupt level value.
Clears the transmit buffer, receiver buffer, or both.
Queries the number of data bytes in the input buffer.
Enables/Disables the UART receivers.
Queries the status of the UART receivers.
Queries the handshake line status.
Queries the output FIFO, returns 1 if half full.
Enables/Disables the UART transmitters.
Queries the status of the UART transmitters.
Receives unquoted string from external device.
Receives binary block of data from external device.
Sends a text string from host computer to external device.
Sends binary data block from host computer to external device.
Returns value of Operation Status Condition Register.
Sets value of Operation Status Enable Register.
Returns value of Operation Status Enable Register.
Returns value of Operation Status Event Register.
Presets the Status system registers and conditions.
Always returns a 0.
Sets value of Questionable Status Enable Register.
Returns value of Questionable Status Enable Register.
Returns value of Questionable Event Register.
See Also
page 26
page 27
page 27
page 27
page 27
page 27
page 27
page 27
page 28
page 28
page 29
page 30
page 31
page 31
page 34
page 34
page 34
page 35
page 35
page 36
page 36
page 36
page 37