Command Quick Reference - HP E1361A 4X4 User Manual

Relay matrix module

Hide thumbs

Table Of Contents

Table of Contents

Command

ABORt

ARM

:COUNt <number> MIN | MAX

:COUNt? [MIN | MAX]

DISPlay

:MONitor:CARD <number | AUTO>

:MONitor[:STATe] <boolean>

INITiate

:CONTinuous <mode>

:CONTinuous?

[:IMMediate]

OUTPut

[:STATe] <state>

[STATe]?

[ROUTe:]

CLOSe <channel _list>

CLOSe? <channel _list>

OPEN <channel_list>

OPEN? <channel _list>

SCAN <channel_list>

SCAN:MODE NONE | VOLT

STATus

:OPERation:ENABle

:OPERation[:EVENt]?

SYSTem

:CDEScription? <number>

:CPON <number | ALL>

:CTYPe? <number>

:ERRor?

TRIGger

[:IMMediate]

:SOURce BUS

:SOURce EXTernal

:SOURce HOLD

:SOURce IMMediate

:SOURce?

Command

Title

*RST

Reset

*TRG

Bus Trigger

*TST?

Self-Test

Chapter 5

All manuals and user guides at all-guides.com

The following tables summarize SCPI and IEEE 488.2 Common (*) Commands for

relay matrix modules used in a switchbox.

Abort a scan in progress.

Multiple scans per INIT command.

Query number of scans.

Selects module to be monitored.

Selects monitor mode.

Enables/disables continuous scanning.

Query continuous scan state.

Starts a scanning cycle.

Enables/disables "Trig Out" pulse.

Query port enable state.

Close channel(s).

Query channel(s) closed.

Open channel(s).

Query channel(s) opened.

Define channels for scanning.

Sets scan mode.

Enables the Operation Status Register to set a bit in the Status Register.

Returns status of Operation Status Register.

Returns description of module in a switchbox.

Sets specified module to its power-on state.

Returns the module type.

Returns error number/message in a switchbox Error Queue.

Causes a trigger to occur.

Trigger source is *TRG.

Trigger source is "Event In".

Hold off triggering.

Continuous (internal) triggers.

Query scan trigger source.

IEEE 488.2 Common Commands Quick Reference

Opens all channels, and invalidates current channel list for scanning. Sets ARM:COUN 1, TRIG:SOUR

IMM, and INIT:CONT OFF

When scan is enabled and trigger source is TRIG:SOUR BUS, use the *TRG command to trigger the

switchbox to advance the scan.

Always returns 0.