HP E1419A User Manual page 298

Initializing the
Status System
Power-on
STAT:PRESET
Subsystem Syntax
Chapter 6
The following table shows the effect of Power-on, *RST, *CLS and
STATus:PRESet on the status system register settings.
SCPI
Transition
Filters
preset
*RST none
*CLS none
preset
STATus
:OPERation
:CONDition?
:ENABle <enable_mask>
:ENABle?
[:EVENt]?
:NTRansition <transition_mask>
:NTRansition?
:PTRansition <transition_mask>
:PTRansition?
:PRESet
:QUEStionable
:CONDition?
:ENABle <enable_mask>
:ENABle?
[:EVENt]?
:NTRansition <transition_mask>
:NTRansition?
:PTRansition <transition_mask>
:PTRansition?
The Status system contains four status groups
•
Operation Status Group
•
Questionable Data Group
•
Standard Event Group
•
Status Byte Group
This SCPI STATus subsystem communicates with the first two groups while
IEEE-488.2 Common Commands (documented later in this chapter) communicate
with Standard Event and Status Byte Groups.
SCPI SCPI
Enable Event
Registers Registers
preset clear
none none
none clear
preset none
HP E1419 Command Reference 297
STATus
IEEE 488.2 IEEE 488.2
Registers Registers
ESE and SRE SESR and STB
clear clear
none none
none clear
none none