Command Quick Reference - HP E1364A User Manual

Command Quick Reference

Command
ABORt
ARM :COUNt < number >
:COUNt? [MIN | MAX]
DISPlay :MONitor:CARD < number > | AUTO
:MONitor[:STATe] < mode >
INITiate :CONTinuous < mode >
:CONTinuous?
[:IMMediate]
OUTput [:STATe] < mode >
[:STATe]?
CLOSe < channel_list >
[ROUTe:]
CLOSe? < channel_list >
OPEN < channel_list >
OPEN? < channel_list >
SCAN < channel_list >
SCAN:MODE NONE | VOLT
SCAN:MODE?
STATus :OPERation:ENABle
:OPERation[:EVENt]?
:CDEScription? < number >
SYSTem
:CPON < number > | ALL
:CTYPe? < number >
:ERRor?
TRIGger [:IMMediate]
:SOURce BUS
:SOURce EXTernal
:SOURce HOLD
:SOURce IMMediate
:SOURce?
Command Title
*RST Reset
*TRG Bus Trigger
*TST? Self-Test
62 HP E1364A Form C Switch Command Reference
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
SCPI Commands Quick Reference
Description
Abort a scan in progress.
Multiple scans per INIT command.
Query number of scans.
Selects module to be monitored.
Selects monitor mode.
Enables/disables continuous scanning.
Query continuous scan state.
Starts a scanning cycle.
Enables/disables "Trig Out" pulse.
Query port enable state.
Close channel(s).
Query channel(s) closed.
Open channel(s).
Query channel(s) opened.
Define channels for scanning.
Sets scan mode.
Query the Scan Mode.
Enables the Operation Status Register to set a bit in the
Status Register.
Returns status of Operation Status Register.
Returns description of module in a switchbox.
Sets specified module to its power-on state.
Returns the module type.
Returns error number/message in a switchbox Error Queue.
Causes a trigger to occur.
Trigger source is *TRG.
Trigger source is "Event In" BNC.
Hold off triggering.
Continuous (internal) triggers.
Query scan trigger source.
IEEE 488.2 Common Commands Quick Reference
Description
Opens all channels, and invalidates current channel list for scanning. Sets
ARM:COUN 1, TRIG:SOUR IMM, and INIT:CONT OFF.
When scan is enabled and trigger source is TRIG:SOUR BUS, use the
*TRG command to trigger the switchbox to advance the scan.
Always returns 0.
Chapter 5