Output:ttltrg<N>[:State]; Output:type; Output:ttltrg<N>[:State] 1 | 0 | On | Off; Output:type Passive | Active,(@<Ch_List>) - HP E1419A User Manual

Usage
OUTPut:TTLTrg<n>[:STATe]
Parameters
Comments
Usage
OUTPut:TTLTrg<n>[:STATe]?
Comments
Usage

OUTPut:TYPE

Chapter 6
•
Related Commands: OUTP:TTLT:SOUR
OUTP:TTLT:SOUR?
OUTPut:TTLTrg<n>:STATe <ttltrg_cntrl> specifies which VXIbus TTLTRG line
is enabled to source a trigger signal when the module is triggered. TTLTrg<n> can
specify line 0 through 7. For example, ...:TTLTRG4, or TTLT4 for VXIbus
TTLTRG line 4.
Parameter Parameter
Name Type
ttltrg_cntrl boolean (uint16)
•
Only one VXIbus TTLTRG line can be enabled simultaneously.
•
When Accepted: Not while INITiated
•
Related Commands: ABORT, INIT..., TRIG...
•
*RST Condition: OUTPut:TTLTrg<0 through 7> OFF
OUTP:TTLT2 ON
OUTPUT:TTLTRG7:STATE ON
OUTPut:TTLTrg<n>[:STATe]? returns the current state for TTLTRG line <n>.
•
Returned Value: Returns 1 or 0. The C-SCPI type is int16.
•
Related Commands: OUTP:TTLT<n>
OUTP:TTLT2?
OUTPUT:TTLTRG7:STATE?
OUTPut:TYPE <select>,(@<ch_list>) sets the output drive characteristic for digital
SCP channels.
enter statement will return on of FTR, SCP,
or TRIG
Range of
Values
1 | 0 | ON | OFF
Enable TTLTRG2 line to source a trigger
Enable TTLTRG7 line to source a trigger
See if TTLTRG2 line is enabled (returns 1
or 0)
See if TTLTRG7 line is enabled
HP E1419 Command Reference 255
OUTPut
Default
Units
none