Diagnostic:calibration:tare[:Otdetect]:Mode; Diagnostic:calibration:tare[:Otdetect][:Mode]; Diagnostic:calibration:tare[:Otdetect][:Mode] 0 | 1 - HP E1419A User Manual

DIAGnostic

DIAGnostic:CALibration:TARE[:OTDetect]:MODE

Parameters
Comments
Usage
DIAGnostic:CALibration:TARE[:OTDetect]:MODE?
Comments
224 HP E1419 Command Reference
DIAGnostic:CALibration:TARE[:OTDetect]:MODE <mode> sets whether Open
Transducer Detect current will be turned off or left on (the default mode) during the
CAL:TARE operation.
Parameter Parameter
Name Type
mode boolean (uint 16)
•
When <mode> is set to 0 (the *RST Default), channels are tare calibrated with
their OTD current off. When <mode> is 1, channels that have their OTD current
on (DIAGnostic:OTDetect ON,(@<ch_list>)) are tare calibrated with their OTD
current left on.
•
By default (*RST) the CALibration:TARE? command will calibrate all channels
with the OTD circuitry disabled. This is done for two reasons: first, most users do
not leave OTD enabled while taking readings, and second, the
CALibration:TARE? operation takes much longer with OTD enabled. However,
for users who intend to take readings with OTD enabled, setting
DIAG:CAL:TARE:OTD:MODE to 1, will force the CAL:TARE? command to
perform calibration with OTD enabled on channels so specified by the user with
the DIAG:OTD command.
•
Related Commands: *CAL?, CAL:SET, DIAG:CAL:SET:MODE?
•
*RST Condition: DIAG:CAL:TARE:MODE 0
configure OTD on during CAL:TARE
DIAG:CAL:TARE:MODE 1
CAL:TARE?
DIAGnostic:CALibration:TARE[:OTDetect]:MODE? returns the currently set
mode for controlling Open Transducer Detect current while performing
CAL:TARE? operation.
•
Returns a 0 when OTD current will be turned off during CAL:TARE?. Returns 1
when OTD current will be left on during CAL:TARE? operation. The C-SCPI
type is int16.
•
Related Commands: DIAG:CAL:TARE:MOD, DIAG:OTD, CAL:TARE?
•
*RST Condition: DIAG:CAL:TARE:MODE 0
Range of
Values
0 | 1
set mode for OTD to stay on
start channel tare cal.
Default
Units
volts
Chapter 6