Status:operation:ptransition; Status:preset - HP E1419A User Manual

STATus
Parameters
Comments
Usage

STATus:OPERation:PTRansition?

Comments
Usage

STATus:PRESet

302 HP E1419 Command Reference
zero, a positive transition of the Condition register bit will not change the Event
register bit.
Parameter Parameter
Name Type
transition_mask numeric (uint16)
•
transition_mask may be sent as decimal, hex (#H), octal (#Q), or binary (#B).
•
If both the STAT:OPER:PTR and STAT:OPER:NTR registers have a
corresponding bit set to one, any transition, positive or negative will set the
corresponding bit in the Event register.
•
If neither the STAT:OPER:PTR or STAT:OPER:NTR registers have a
corresponding bit set to one, transitions from the Condition register will have no
effect on the Event register.
•
Related Commands: STAT:OPER:PTR?, STAT:OPER:NTR
•
Set to all ones by: STAT:PRESet and power-on.
•
*RST Condition: No change
STAT:OPER:PTR 16
STATus:OPERation:PTRansition? returns the value of bits set in the Positive
Transition Filter (PTF) register.
•
Returned Value: Decimal weighted sum of all set bits. The C-SCPI type is uint16.
•
Related Commands: STAT:OPER:PTR
•
*RST Condition: No change
STAT:OPER:PTR?
STATus:PRESet sets the Operation Status Enable and Questionable Data Enable
registers to 0. After executing this command, none of the events in the Operation
Event or Questionable Event registers will be reported as a summary bit in either the
Range of
Values
0-32767
When "Measuring" bit goes true, set bit 4 in
Status Operation Event register.
Enter statement returns current value of bits
set in the PTF register
Default
Units
none
Chapter 6