Table of Contents
Advertisement
3-5 To Install LAN Drivers (for 86SP2-L only)
3-5.1 RTL8101L LAN driver on Windows ME / 2000 / XP
1. When you newly install Windows ME, Windows 2000 or Windows
XP, the system will detect the LAN Controller on board and configure
it automatically into system. Therefore, users need not bother to install
the LAN controller into these operating systems.
2. To verify the existence of RTL8101L Controller and Driver, please
enter the "Control Panel" of your system and click "Network" to open
the "Configuration" screen. You can then see the "Realtek8139 (A/
B/C) PCI Fast Ethernet Adapter" is already installed in system.
3-5.2 RTL8101L LAN driver on Windows 9X
The LAN driver contained in the Support CD is not included in the
Autorun Menu. To install RTL8101L LAN driver on Windows 9X, please
follow the steps shown below:
1. On the "Start" screen of your system, please click to the following
path:
\My Computer\properties\Device manager
2. In the "Device manager" screen, you can see the item " PCI Ethernet
Controller" with a yellow question mark on its left side, which indicates
that the LAN controller is already detected by system but the driver
for this on-board RTL8101L Ethernet Controller is not installed yet.
Please point to this item with your mouse and double click on it (or
click the "Properties" button).
3. Instantly, the "PCI Ethernet Controller Properties" screen shows up.
Please click the "General" bar to continue.
4. In the "General" screen, click "reinstall Driver" button to continue.
Please note that the status of "Device Usage" should stay at "Exists
in all hardware profiles".
Chapter 3 Software Setup
Click Here
47
Advertisement
Table of Contents
