Restart Signal; Detection Access; Detection Exit; Dynamic Configuration In Use - Leuze electronic LBK SBV Original Operating Instructions

8 Maintenance and troubleshooting
8.3.5

Restart signal

If configured, every time the system is waiting for the restart signal or the restart signal is received, the event
is logged as WAITING or RECEIVED.
Format: Restart signal WAITING/RECEIVED
Example:
20 2020/11/18 16:47:25 [INFO] CONTROLLER Restart signal RECEIVED
8.3.6

Detection access

Every time motion is detected, a detection access is logged with additional parameters depending on the
selected verbosity level: the detection field number, the sensor which detected the motion, the detection
distance (in mm) and the detection angle (°) (see Verbosity level for detection access and exit events on
page 83).
Format: Detection access (field #n, distance mm/azimuth°)
Example:
20 2020/11/18 16:47:25 [INFO] SENSOR #1 Detection access (field #1, 1200 mm/30°)
8.3.7

Detection exit

After at least one detection access event, a detection exit event related to the same field is logged when the
detection signal returns to its default no-motion status.
Depending on the selected verbosity level additional parameters are logged: the detection field number, the
sensor which detected the motion.
Format: Detection exit (field #n)
Example:
20 2020/11/18 16:47:25 [INFO] CONTROLLER Detection exit (field #1)
8.3.8

Dynamic configuration in use

At every change of the dynamic configuration, the new ID of the dynamic configuration selected is logged.
Format: Dynamic configuration #1
Example:
20 2020/11/18 16:47:25 [INFO] CONTROLLER Dynamic configuration #1
8.3.9

Muting status

Every change of the muting status of each sensor is logged as disabled or enabled.
Note: the event indicates a change of the muting status of the system. It does not correspond to the muting
request.
Format: Muting disabled/enabled
Example:
20 2020/11/18 16:47:25 [INFO] SENSOR#1 Muting enabled
Leuze electronic GmbH + Co. KG Sensor LBK SBV 85