Chain Examples; Save And Print The Configuration; Set The Controller Ethernet Parameters - Leuze electronic LBK SBV Original Operating Instructions

7 Installation and use procedures
7.2.10

Chain examples

Chain with controller at the end of the chain and a sensor with bus terminator
Chain with controller inside the chain and two sensors with bus terminator
7.2.11

Save and print the configuration

1. In the application, click APPLY CHANGES: the sensors will save the inclination set and the surrounding
environment. The application will transfer the configuration to the controller, and once transfer is
complete it will generate a configuration report.
2. Click to save and print the report.
Note: to save the PDF, a printer must be installed on the computer.
3. Ask the authorized person for a signature.
7.2.12

Set the controller Ethernet parameters

1. Ensure the controller is turned on.
2. Press the Network parameter reset button and hold it down during steps 3 and 4.
3. Wait for five seconds.
4. Wait until all the six LEDs on the controller turns steady green: the Ethernet parameters are set to their
default values (see Ethernet connection (if available) on page 93).
5. Configure the controller again.
Leuze electronic GmbH + Co. KG Sensor LBK SBV 69