Manage The Configuration; Configuration Checksums; Configuration Reports; Change The Configuration - Leuze electronic LBK SBV Original Operating Instructions

7 Installation and use procedures
7.4

Manage the configuration

7.4.1

Configuration checksums

In the LBK Designer application in Settings > Configuration checksums, it is possible to consult:
the configuration report hash, a unique alphanumeric code associated with a report. It is computed
l
considering the entire configuration, plus the time of the commit and the name of the computer which did
it.
dynamic configuration checksum, associated with a specific dynamic configuration. It considers both
l
common and dynamic parameters.
7.4.2

Configuration reports

After changing the configuration, the system generates a configuration report with the following information:
configuration data
l
unique hash
l
date and time of configuration change
l
name of computer in which the change was inserted
l
The reports are documents that cannot be changed and can only be printed and signed by the machinery
safety manager.
Note: to save the PDF, a printer must be installed on the computer.
7.4.3

Change the configuration

The system is disabled during configuration. Prepare opportune safety measures in the
dangerous area protected by the system before configuring the system.
1. Start the LBK Designer application.
2. Click User and enter the admin password.
Note: after five wrong password entries, application authentication is blocked for one minute.
3. Depending on what you want to change, follow the instructions below:
To change...
Monitored area and
sensors
configuration
Node ID
Function of inputs
and outputs
Muting
Sensor inclination
Sensor number
and positioning
4. Click APPLY CHANGES.
5. Upon conclusion of transfer of the configuration to the controller, click
Note: to save the PDF, a printer must be installed on the computer.
Leuze electronic GmbH + Co. KG
WARNING
Click Configuration
Click Settings > Node ID Assignment
Click Settings > Digital Input-Output
Click Settings > Muting
Loosen the side screws on the sensor and orient the sensors to the desired
inclination.
Click Configuration
Then...
Sensor LBK SBV
to print the report.
73