Verbosity Level; Verbosity Level For Detection Access And Exit Events - Leuze electronic LBK SBV Original Operating Instructions

8 Maintenance and troubleshooting
Event
Muting status
Fieldbus connection
MODBUS connection
Session authentication
Validation
Log download
For further information about the events, see INFO events on the next page and ERROR events (controller)
on page 87.
8.2.10

Verbosity level

There are six verbosity levels for the log. The verbosity can be set during the configuration of the system via
the LBK Designer application (Settings > Activity History > Log verbosity level).
Depending on the selected verbosity level, the events are logged in accordance to the following table:
Event
Diagnostic errors
System Boot
System configuration
Factory reset
Stop signal
Restart signal
Detection access
Detection exit
Dynamic configuration in
use
Muting status
8.2.11

Verbosity level for detection access and exit events

Depending on the selected verbosity level, the detection access and exit events are logged as follows:
LEVEL 0: no detection info is logged
l
LEVEL 1: the events are logged at controller level and the additional information are the detection
l
distance (in mm) and the detection angle (in °) in detection access.
Format:
CONTROLLER Detection access (distance mm/azimuth°)
CONTROLLER Detection exit
LEVEL 2: the events are logged in a single field at controller level and the additional information are:
l
detection field, detection distance (in mm) and detection angle (in °) in access, and detection field at exit.
Format:
CONTROLLER Detection access (field #n, distance mm/azimuth°)
CONTROLLER Detection exit (field #n)
Leuze electronic GmbH + Co. KG
Type
INFO
INFO
INFO
INFO
INFO
INFO
Level 0
Level 1
(default)
x x
x x
x x
x x
x x
x x
- See Verbosity level for detection access and exit events
- See Verbosity level for detection access and exit events
- -
- -
Sensor LBK SBV
Level 2 Level 3
x x
x x
x x
x x
x x
x x
below
below
- -
- -
Level 4 Level 5
x x
x x
x x
x x
x x
x x
x x
- x
83