Installation And Use Procedures; Before Installation; Materials Required; Operating System Required - Leuze electronic LBK SBV Original Operating Instructions

7 Installation and use procedures
7

Installation and use procedures

7.1

Before installation

7.1.1

Materials required

Two tamper-proof screws (see Tamper-proof screws specifications on page 95) to mount each sensor.
l
Cables to connect the controller to the first sensor and the sensors to one another, see CAN bus cables
l
recommended specifications on page 95.
A data USB cable with a micro-USB connector (micro-B type) or, only if the Ethernet port is available, an
l
Ethernet cable to connect the controller to the computer.
A bus terminator (product code: 50040099) with resistance of 120 Ω for the last sensor of the CAN bus.
l
A screwdriver for tamper-proof screws (see Tamper-proof screws specifications on page 95) to be used
l
with the Hex pin security bit supplied in the controller package.
7.1.2

Operating system required

Microsoft Windows 10 or later
l
Apple OS X 11.0 or later
l
7.1.3

Install the LBK Designer application

Note: if the installation fails, the dependencies needed by the application may be missing. Update your
operating system or contact our Technical Support to receive assistance.
1. Download the application from the www.leuze.com website (from the product download area) and install
it on the computer.
2. With Microsoft Windows operating system, download and install from the same site also the driver for
USB connection.
3. Start the application.
4. Choose the connection mode (USB or Ethernet).
Note: the default IP address for the Ethernet connection is 192.168.0.20. The computer and the
controller must be connected to the same network.
5. Set a new admin password, memorize it and provide it only to people who are authorized to change the
configuration.
6. Select the sensor type and the number of sensors.
7. Set the country in which the system is installed.
Note: this setting does not have any effect on system performance.
8. Only for LBK SBV-01, select the application type (Fixed or Vehicle mount).
Note: the two algorithms are optimized to minimize the interference between sensors based on the
installation conditions. Even though this choice does not affect the performance and the robustness, it is
mandatory to select the correct application type.
7.1.4

Initiate LBK SBV System

1. Calculate the position of the sensor (see Sensor position on page 52) and the depth of the dangerous
area (see Dangerous area calculation on page 54).
2. Install the controller on the next page.
3. Open the LBK Designer application.
4. Optional: Synchronize the controllers on the next page.
5. Define the area to be monitored on page 63.
6. Configure the inputs and outputs on page 63.
7. Optional: Mount bracket for z-axis rotation (roll) on page 65.
Leuze electronic GmbH + Co. KG Sensor LBK SBV 61