Dynamic Configuration Through The Safety Fieldbus - Leuze electronic LBK SBV Original Operating Instructions

4 Get to know LBK SBV System
Example 1
The first digital input has been linked to the dynamic configuration.
Dynamic
configuration
number
#1
#2
0 = signal deactivated; 1 = signal activated
Example 2
The second digital input has been linked to the dynamic configuration.
Dynamic
configuration
number
#1
#2
0 = signal deactivated; 1 = signal activated
Example 3
Both digital inputs have been linked to the dynamic configuration.
Dynamic
configuration
number
#1
#2
#3
#4
0 = signal deactivated; 1 = signal activated
4.7.5

Dynamic configuration through the safety Fieldbus

To activate the dynamic system configuration, connect an external safety PLC that communicates through
the safety Fieldbus to the controller. This makes it possible to dynamically switch between all the preset
configurations, therefore up to 32 different configurations. For all the parameters used for each
configuration (see Dynamic system configuration on the previous page).
For details about the supported protocol, please refer to the Fieldbus manual.
Before activating the dynamic system configuration through the safety Fieldbus, ensure it has
not already been activated through the digital inputs. If the activation is set for both the digital
inputs and the safety Fieldbus, LBK SBV System uses the digital input data and ignores the
dynamic changes made through the safety Fieldbus.
Leuze electronic GmbH + Co. KG
Input 1
0
1
Input 1
-
-
Input 1
0
1
0
1
WARNING
Input 2
-
-
Input 2
0
1
Input 2
0
0
1
1
Sensor LBK SBV 34